Why Central Coast owners are switching from tile
A big share of the Coast's housing was built from the 1960s through the 1990s with concrete or terracotta tiles. Those roofs are now at the age where ridge capping cracks, valley irons rust, tiles slip in strong winds and moss holds moisture against the tile. You can restore them — but restoration typically lasts 15–20 years, while a sheet-metal roof can last up to 40 (Canstar).
Metal also means fewer points for water to get in: a few long sheets instead of hundreds of overlapping tiles, and no mortar-bedded ridges to crack.
What's included
- Tile removal and disposal
- Old battens removed; new steel battens fitted
- Sarking / anticon blanket
- COLORBOND® sheets, ridges and flashings
- Re-flashing around chimneys, vents and walls
- Optional gutters, fascia, downpipes and whirlybirds
What's involved
We remove and dispose of the tiles, take off the old tile battens, and install new steel battens at the spacing the metal roof needs. Then sarking, the new Colorbond sheets, ridges and flashings. Because tile battens and metal battens are set differently, this isn't a shortcut job — it's the step that makes the new roof last.
It's also a natural time to replace gutters and fascia, add whirlybirds for roof-space ventilation, or put in a skylight.
Recent tile to metal conversion jobs

Before
After
Before
AfterWhat it costs
| Item | Typical range | Source |
|---|---|---|
| Tile to Colorbond conversion (Sydney) | $20,000 – $35,000 | whatsthedamage.com.au |
| Tile removal & disposal | $25 – $45/m² | goingrate.com.au |
| New battens, installed | $15 – $28/m² | goingrate.com.au |
| Sarking, installed | $12 – $22/m² | goingrate.com.au |
Published 2026 ranges from Sydney/NSW cost guides — there's no Central Coast-only survey. Worked example from whatsthedamage.com.au: a 180 m² two-storey Sydney conversion to Colorbond Ultra came to about $37,500 including scaffold, gutters and fascia. Your price depends on size, pitch, access and what we find. Every quote we give is written and itemised.
Try the roof cost calculator →
How the job runs
Quote
Measure-up, roof-space check, itemised quote.
Strip tiles
In sections, with tiles lowered and removed from site.
Battens & sarking
New battens at metal-roof spacing, sarking laid.
Sheet & flash
Colorbond fixed, flashed and sealed; site cleaned.
Tile to Metal Conversion FAQs
Is my roof frame strong enough for metal?
Almost always. A metal roof is much lighter than tile, so the existing frame is usually more than adequate. We check every frame before quoting.
Will a metal roof be hotter than tile?
Not if it's done properly. Sarking under the sheet plus a lighter Colorbond colour with Thermatech® technology keeps heat gain down, and whirlybirds help vent the roof space.
How long does a conversion take?
Typically several days for a single-storey home, weather permitting. The house is kept weather-tight overnight.
What happens to the old tiles?
We remove them from site. Intact tiles can sometimes be reused or recycled.
Your protections on this job, under NSW law
- Work over $5,000 must be done by a licensed contractor. Ours: 463604C.
- A written contract for anything over $5,000, and no more than a 10% deposit before work starts.
- Home Building Compensation cover on work over $20,000.
- Statutory warranties: 6 years for major defects, 2 years for other defects.


